 |
 |
 |
|
Mini-Ductor® Venom MDV-777
Mini-Ductor Venom - generates Invisible Heat® to release ferrous and some non-ferrous metals from corrosion and thread lock compounds without the dangers of open flame and up to 90% faster – ¾” nuts are turned red hot in less than 15 seconds. 110v Mini-Ductor Venom power supply. Venom also includes the following enhancements over the Mini-Ductor II: - Angled Design with Trigger: Venom’s lightweight, ergonomic design allows for induction heat to access hard-to-reach places more easily
- Coil Twist Lock™: Coils now lock down with one simple turn (no more thumb screws), and Venom works with all Mini-Ductor coils
- LED usage indicator: A red LED will light under fault conditions, and a green LED will light while the trigger is active and the tool is heating properly
- Fault override delay: Any event that causes the red LED to illuminate will protect the tool by starting a three-second lockout
- Fan operation enhancements: The fan continues to run after the trigger is released to aid in thermal cycle time reduction, and will stay powered when the thermal switch opens to aid in cooling
- User-controlled LED switch: As long as the tool is powered and the internal power supply is operating, the LED will remain lit when the switch is on
- Two-year limited warranty: Covers parts and labor.
- 110V (MD-777)
The Mini-Ductor Venom includes the following:
- Mini-Ductor Venom handheld induction heater
- Three basic coils
- Rugged plastic carrying case
- Operator manual
- Two-year warranty that covers parts and labor
Mini-Ductor VENOM In Action
|
|
|
 |
|
 |
|
Every shop needs one of these! 
